Utilization of Quarry Dust as a Partial Replacement of Sand in Concrete …

The use of quarry dust is also in concrete is also a measure necessary for improvement of concrete strength. River sand was replaced with quarry dust for different mix designs of concrete for 0% ...

Use of Quarry Dust to Replace Sand in Concrete

Abstract- This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room …

Use of quarry waste in concrete and cementitious mortars

In conventional concrete, the introduction of high volumes of limestone quarry dust to concrete mixes is limited due to its negative effects on water demand and strength of concrete.

Strength Properties of Concrete Using Marble Dust Powder

This study looked into the use of marble dust powder in concrete, with varied percentages of marble dust (0%, 5%, 10%, 15% & 20%) replaced by sharp sand in M20 grade concrete mixes, while the ...

Optimum Utilization of Quarry Dust as Partial

Engineers have also used quarry dust as total replacement of sand in concrete. Quarry dust concrete for curing age of 28 days resulted higher compressive strength than river sand concrete [5] [6 ...

Strength and durability of concrete by partial

It has been shown that increasing the proportion of quarry dust in concrete may increase its workability by as much as thirty percent for M40 grade concrete. It …

Experimental Investigation on the Effect of Replacement

This study aims to investigate the limit up to which stone quarry can be replaced with sand for M35 grade of concrete and to investigate the combined effect of stone quarry dust (10%) and ...

(PDF) THE USE OF QUARRY DUST FOR PARTIAL …

This research was carried out to investigate the effect of partially replacing cement with quarry dust in cement-sand mortar. Tests including setting times, water absorption, compressive strength ...

Use of quarry waste in concrete and cementitious …

Even though cement replacement by waste quarry dust leads to increased water absorption in ordinary concrete, it is still possible to develop good quality …

Optimization of Indirect Tensile Strength of Modified Asphalt Concrete

Ceramic wastes have contributed hugely to environmental pollution in our societies, mostly because it is non-biodegradable and not reused in any significant quantity presently. Research has confirmed the feasibility of incorporating these wastes into cement concrete and asphalt concrete production. In this study, the use of ceramic tile dust …

Partial Replacement of Sand by Quarry Dust in Concrete

Quarry dust can be used as an economic alternative to the natural sand. In this investigation an attempt is made to utilize quarry dust as a partial substitute for natural sand in producing concrete. Natural sand is replaced by Quarry dust at an interval of 5%, 10%, 15%, 20% and 25%. Mix proportions for M20 concrete is prepared with reference ...

Sustainable Utilisation of Quarry Dust Waste in …

The quarry dust has been used as a partial replacement for cement proportion at different levels of replacement (25%, 30% and 35%). Quarry dust was …

Performance characteristics of sugarcane bagasse ash and quarry dust …

The various age of curing in concrete effects the quality of paste and splitting the tensile strength. ... (2013) Experimental investigation on self-compacting concrete using quarry dust. Int J Sci Res Publ 3:1–5. Google Scholar Bentz DP, Jensen OM (2004) Mitigation strategies for autogenous shrinkage cracking. Cement Concr …

Use of Quarry Dust to Replace Sand in Concrete

This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room temperature. Also …

Partial Replacement of Sand with Quarry Dust in Concrete

-The reduction in the sources of natural sand and the requirement for reduction in the cost of concrete production has resulted in the increased need to identify substitute material to sand as fine aggregates in the production of concretes especially in Concrete. Quarry dust, a by-product from the crushing process during quarrying activities is one of such …

(PDF) Introduction to Quarry-Dust as Partial Replacement

Quarry dust can be used as. an admixture in concrete efficiently to lessen its impact on. environment and human. It can also be used as partial. replacement of cement in concrete. Cement can be ...

Sustainable Utilisation of Quarry Dust Waste in Concrete: …

The quarry dust has been used as a partial replacement for cement proportion at different levels of replacement (25%, 30% and 35%). Quarry dust was used as the main material in this project to measure the effectiveness of concrete performance. In this research, the quarry dust composition was determined by using X-Ray …

(PDF) Evaluating the feasibility of blending fly ash and quarry dust …

The results obtained in the next stage suggest that even though the use of quarry dust as a partial substitute for sand results in some minor negative effects in the compressive strength and other ...

A Comprehensive Review of Stone Dust in Concrete: …

These include producing concrete using optimal stone dust contents to validate their performance, investigating optimal packing methods to reduce the influence …

EFFECT OF QUARRY DUST AS PARTIAL REPLACEMENT OF SAND IN CONCRETE

Mix design has been developed for three grades using design an approach IS, ACI, USBR, RN.No.4 and BRITISH for both conventional concrete and quarry dust concrete. Tests were conducted on cubes and beams to study the strength of concrete made of Quarry Rock Dust and the results were compared with the Natural Sand Concrete.

Experimental Investigation on the Effect of Replacement …

effect of w/c ratio and admixtures on the characteristics of hollow concrete blocks. Quarry dust from three different sources were procured and tested before using the same for the research program. The results obtained for quarry were compared with that of the sand. Table I shows the properties of sand and the three types of quarry dust tested.

Strength and durability properties of quarry dust powder …

It can be inferred from the results that using quarry dust powder in concrete blocks as a replacement for fine aggregates is an economic, effective and sustainable method in utilizing the generated waste. ... This could be due to the ideal combination of quarry dust powder filling effect and sufficiently moderate addition of …

[PDF] FLEXURAL AND TENSILE STRENGTH PROPERTIES OF CONCRETE USING

The proportion of lateritic sand was varied from 0% to against quarry dust at intervals of 25%, using concrete mix of 1:1.5:3 and water/cement ratio of 0.65. Concrete samples were prepared, cured for 28 days, and tested in the laboratory to destruction in order to determine their flexural and tensile strength properties.

Quarry dust as river sand replacement in cement masonry blocks: Effect

Therefore, water to cement ratio was increased for concrete with quarry dust to sustain similar workability of conventional concrete [31, 32]. On the other hand, the presence of quarry dust improved the mechanical characteristics and durability aspects of the concrete [29, 33]. Quarry dust was also used in self-compacting concrete.

A Comprehensive Review of Stone Dust in Concrete: …

Despite the variation in the effect of stone dust on concrete workability due to the different physical characteristics of SD found in the various mining companies around the globe, ... Akeke, G.A. Compressive strength of concrete using lateritic sand and quarry dust as fine aggregate. ARPN J. Eng. Appl. Sci. 2012, 7, 81–92. [Google Scholar]

(PDF) Sustainable Utilisation of Quarry Dust …

The use of quarry dust is also in concrete is also a measure necessary for improvement of concrete strength. River sand was replaced with quarry dust for different mix designs of concrete for 0% ...

The Utilization of Quarry Dust as Fine …

It is also found that utilization of quarry dust as fine aggregates in concrete provides sufficient workability and also the required strength.

(PDF) BEHAVIOUR OF CONCRETE ON THE USE OF QUARRY DUST …

We are investigating the potential of using quarry waste and its effect on the strength and workability of concrete. This paper reports the experimental study which investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25).

Utilization of Basaltic Quarry Dust as a Partial

This research was conducted to examine the potential of basaltic crusher dust as a partial replacement for Portland Pozzolana cement in hollow concrete block (HCB) production. Quarry dust is one of the waste materials abundantly available and pozzolanic material in the quarry industry. In doing so, physical tests of cement pastes …

Feasibility Study on Concrete Made with Substitution …

Feasibility Study on Concrete Made with Substitution of Quarry Dust: A Review. by. Buthainah Nawaf AL-Kharabsheh. 1, Mohamed Moafak Arbili. 2, Ali Majdi. 3, Jawad Ahmad. 4,*, Ahmed Farouk Deifalla. …

Effect of Quarry Dust as Partial Replacement of Sand in Concrete

Effect of Quarry Dust and Fly Ash Mix on strength properties of M40 grade Concrete. Anjali H Jamale U. R. Kawade. Engineering, Environmental Science. 2015. this paper presents the variation in the strength of concrete when replacing sand by quarry dust and also effect of inclusion of Fly Ash with the addition Quarry Dust.

Effect of quarry rock dust on the flexural strength of concrete

Abstract. The effect of quarry dust on the flexural strength of concrete has been experimentally studied and reported in this paper. Concrete used was prepared by replacing 25% and of sand by weight with quarry dust. Also, conventional sand concrete was prepared as reference concrete for comparison. 100 mm cube and 100 × …

Use of Quarry Dust to Replace Sand in Concrete

We are investigating the potential of using quarry waste and its effect on the strength and workability of concrete. This paper reports the experimental study which investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25).

Compressive strength of concrete using lateritic sand and quarry dust

This waste problem may be avoided as it could be converted into useful application in concrete production. 2.3 Concrete with quarry dust as fine aggregate In a study in Thailand by Khamput [29] on the compressive strength of concrete using quarry dust as fine aggregate and mixing with admixture type E, it was found that with 70% quarry dust …